Product Categories

Machine knife more point










PCB Depanelizer (YLVC-1 )

1. The machine uses a unique multi-cut method even more, the board consists of six blades cutting is completed, the upper and lower pieces as a group, to form a cutting unit. Are A, B, C, three groups. The entire cutting process into three phases, A set of blades to cut the board 40%, followed by B from A blade blade again cut off tank run over, completed 40% of the amount cut again, and finally by the blade cutting the final group C 20% and light repair, since the amount of each cut is small, so the stress generated during cutting off a more traditional way to reduce by more than 80 percent, a good segmentation smooth edge of the board, the board is very smooth, not twisted not Alice. Is currently available only go after the cutting of aluminum plate to ensure that no deformation of the machine

2. Because of the amount of each cut is small, so the stress generated during cutting off a more traditional way to reduce stress by more than 80 percent, a good segmentation smooth edge of the board, the board is very smooth, not twisted not Alice. It is currently available only to go sub-board machine plate to ensure no deformation after cutting aluminum

3. Because multiple cutting's sake, very smooth cutting process, greatly improving the positioning capability V-CUT groove, even if V-CUT very shallow groove boards, the cutting of aluminum as deformation, avoid bad produce.

4. Due to the small blade cutting force, and the use of imported high-speed steel, blade durability greatly improved blade life when the aluminum plate is divided up over three years. Blade adjustment simple and convenient, without relying on tools, hand you can easily separate numeric adjust and improve production efficiency. Design concept of humanity.

5Devices are equipped with stepless speed control device, control speed freely, installed plus reversing control knob, emergency stop buttons, increase productivity

6. Circular blade can be turned several times and then grinding, reduce production costs. Fortune 500 designated suppliers

Specification

Size

400×400×330mm/2440mm

Max.cutting length

No limit

Separate speed

0-400mm/s

Cutting thickness

1.0-3.5mm