Product Categories

The maintenance of the PCB of the enterprise is very importantThe maintenance of the PCB of the enterprise is very important


The use of multi machine itself is very large in production, so the problem is normal.. The factory for the extension of the service life of the equipment is very important, equipment maintenance is not only improve the PCB board splitting machine service life, and the quality of work is a great security. PCB the reasons for the non work or the abnormal work of the plate machine: lack of battery charger; the electrical connection battery and engine, and the cutter type. Wiring loose or battery bar clip severe oxidation; electromagnetic switch deflector severe erosion or touch terminal and two bad; brush excessive wear and tear, tensile spring break or electric card in the pen container; brush in rectifier oil or serious erosion; brush winding fairing some short or open circuit; armature winding and commutator segment closed place; copper sleeve bearing or wear generated by the rotor of the scanning room; PCB sub machine equipment installation in the wrong direction or new sleeve gap is too large. PCB engine idle: fork device is incorrect, fork sets of reel in the mobile device, the motor gears of the PCB sub machine can not be changed along with the fork. The core of the electromagnetic switch is then set the gap between the too big push rod. The shift of the clutch slip and the flywheel can not be shared. The motor gears of the PCB are severe engine wear rather than with the flywheel ring. Normally open solenoid switch usually ceiling ceiling is often referred to as a normally open solenoid switch, ignition switch is pressed, the core of electromagnetic switch, it has only been siphoning off, and then take it off immediately after being dried. Then they take off immediately did not meet the recommended the intent of the aircraft engines. When the PCB sub machine this shortcoming is common reason is the maintenance coil circuit.